Drilling Results

Tertiary Minerals PLC 20 June 2000 TERTIARY MINERALS PLC DRILLING AT WINDFALL EXTENDS KNOWN MINERALISATION Parallel Zone Of Mineralisation Also Encountered Tertiary Minerals reports that a further round of drilling at it's Windfall project in the historic Bergslagen mining district of south central Sweden has extended the strike length of known mineralisation and encountered a parallel zone of mineralisation. However, testing of Induced Polarisation (IP) geophysical targets has shown that this exploration technique has no further application in this area. Ten diamond drill holes have been completed for a total of 1,077m. Significant results are shown in the table below and include best results of 1.6m of 18p.c. zinc, 6p.c. lead and 160g/t silver in hole 00VD104 at the Vindfall prospect and 0.5m of 28p.c. zinc, 13p.c. lead and 63g/t silver in hole 00SD109 at Sortarnan. A schematic plan showing the location of these and previous Company drill holes is available from the Company. Four holes at the Vindfall prospect tested an IP anomaly in the footwall of the known mineralisation and for extensions of mineralisation on the north-east end of the Vindfall zinc-silver mineralised zone. Hole 00VD104 was designed to follow up mineralisation encountered in a 1997 reverse circulation drill hole (97VR109, which intersected 4m at 9.7p.c. zinc, 2.4p.c. lead, 0.3p.c. copper and 30g/t silver), and also to test at depth a shallow-dipping IP anomaly in the footwall of the known zinc-silver zone. The high grade intersection reported above for hole 00VD104 is believed to extend the mineralisation in 97VR109. The IP anomaly is explained by a parallel zone of barren skarn alteration. Holes 00VD105 and 106 were drilled approximately 100m north-east of the previously known limit of mineralisation at Vindfall. An intersection of 3m of 2.7p.c. zinc, 0.9p.c. lead, 0.1p.c. copper and 23g/t silver from 12.90m depth in 00VD106 demonstrates that it is continuing in that direction and remains open-ended. Hole 00VD103 tested a strong IP anomaly in a demagnetised zone in the footwall of the Windfall mineralisation but encountered only small amounts of haematite and pyrite in granite. Six holes were drilled to test targets at Sortarnan which lies 1500m north-east of, and along strike from, Vindfall. Holes 00SD106-108 and 00SD112 tested geophysical IP targets but only barren skarn altered horizons were intersected. Hole 00SD109 tested the main Sortarnan zinc-silver zone up dip from a previous drill intersection (00SD104 which intersected 7.7m at 10.9p.c. zinc, 4.3p.c. lead and 0.4p.c. copper and 96g/t silver). A narrow intersection of very high-grade mineralisation was made in the predicted position. Perhaps more significantly, hole 00SD109 collared in mineralised bedrock with the first meter of rock beneath the transported overburden assaying 3.9p.c. zinc, 3.3p.c. lead, 0.38p.c. copper and 113g/t silver. This represents a new zone of mineralisation not tested by any of the company's previous drill holes. It is not known if this represents the true thickness of mineralisation at this point or if the hole has clipped the edge of a wider zone of mineralisation. Hole 00SD110, drilled approximately 50m north-east of the limit of the Company's previous drilling at Sortarnan, did not intersect the normally mineralised skarn altered carbonate host rock and it is thought that faulting may have displaced this zone to the north-west. The Company is encouraged that extensions have been found to the Vindfall prospect and that a second zone of mineralisation has been found at Sortarnan. However, the mineralisation is structurally complex and cannot be outlined by IP geophysical methods. The Company is now planning a detailed geochemical sampling programme to delineate further extensions to the mineralisation which remains open in most directions. Further information: Patrick Cheetham, Executive Chairman, Tertiary Minerals Tel: (00 44) (0) 1625 626203 or visit the Company's website : www.tertiaryminerals.com WINDFALL PROJECT MAY/JUNE 2000 DRILLING PROGRAMME TABLE OF SIGNIFICANT DRILL HOLE INTERSECTIONS* Hole No. Drill Zinc Lead Copper Silver From Intersection % % % g/t (downhole) m (ppm) m VINDFALL PROSPECT 00VD104 1.90m 0.8% 0.7% 0.0% 15 54.00m 7.40m 4.3% 1.4% 0.1% 64 63.60m Including 1.61m 18.0% 5.7% 0.2% 160 68.39m Including 0.90m 31.4% 9.9% 0.2% 256 68.60m 00VD106 3.25m 2.7% 0.9% 0.1% 23 12.90m Including 0.30m 7.5% 1.4% 0.0% 25 15.60m SORTARNAN PROSPECT 00SD109 1.05m 3.9% 3.3% 0.4% 113 7.30m Including 0.60m 6.2% 5.4% 0.3% 169 7.60m 2.15m 1.0% 0.7% 0.4% 91 10.50m 2.45m 2.1% 0.7% 0.1% 22 19.70m Including 0.60m 4.1% 0.4% 0.1% 29 19.70m 1.20m 2.1% 0.7% 0.1% 20 33.50m 0.40m 0.2% 0.9% 0.0% - 36.50m 0.50m 28.5% 13.1% 0.2% 63 36.90m 1.00m 0.7% 0.4% 0.0% - 39.60m 0.25m 6.6% 2.1% 0.0% 21 42.75m * Sample intervals assaying greater than 1% combined zinc+copper+lead
UK 100

Latest directors dealings